I am working with the TIDEP-01032 example from the AM243x Motor Control SDK 09.02.00 and don't understand how the EtherCAT Firmware is loaded onto the PRU-ICSSG. In the EtherCAT Slave Simple Demo, ...

Can the IN+ and IN- of the INA180-Q1 current sensing operational amplifier meet the 5B pulse requirements? (Note: The front-end circuit will have a TVS tube, clamp voltage: 38.9V) ...

I encountered a problem when debugging the HRPWM. The EPWMCLK is 100MHz，I think the MEP_ScaleFactor should be 65 or 66 cause the MEP step size is 150ps. But when I use the SFO function, the ...

TPS61165DRVRG4 is constant current LED driver. The LCD module backlight has a spec for both voltage and current. for example, our backlight has a current spec 180mA and voltage spec typ 9.6V, max10.2V ...

I would like to know if there is any easy way to add a protection for short circuit between led+ and led-? It happens quite too often that we destroy either the diode or Rset during the assembly ...

I am using the EMIF interface to access both an external SRAM and an FPGA. Do you recommend adding series resistors (10-22 ohms each) to the EMIF signal lines, since the interface will be running at ...

I am trying to use TPS61165 IC. I am using this IC for LCD Back light control, Which has 27 LED (3S ,9P). Required LCD backlight forward voltage: 9.6V (Typ) Required LCD backlight forward Current: ...

We have found LM5064 for the solution. As per the datasheet page#21 to maintain accuracy, the sense resistor voltage should not be less than 3 mV. But our calculated Vsense voltage comes near 1.5mV.

firewall can config channel (register) and region (memory usage) and must be 0x40000 aligned. in firewall if I config msram 0x70000000 to be locked, is it esquivent that In mpu config, I config msram ...

I'm attempting to create a dual integrator to measure distance from an accelerometer. We have the ACF2101 but we need a larger capacitor for the integration time which is 2 seconds. Schematic is here.

Is it possible to use the signal from the IPROPI pin to perform ripple counting of the brushed dc motor being driven by the DRV8873-Q1 or is the signal not meant for that kind of high resolution ...

For a 6.3v to (-16) v inverter, the Webench advised the attached schematic. But this design cant be simulated. Is there a spice model for LM5164 device thus the design can be proof.